Kenmore Calypso Manual Diagnostic Flame

My Calypso Won't Spin. For your Calypso washing machine to spin several things need to happen. This is a fairly complicated mechanical system so check the easy stuff, and If that doesn't work call an appliance repair company you trust. In many cases large/ expensive repairs on a Calypso washing machine are not a good idea. Kenmore Elite Calypso Manualyour Kenmore Elite 2 washer. The diagram(s) below can help you find the right part. If you’d like help, we invite you to call our customer service number at the top of the page, or click chat. Whirlpool Calypso Washer Troubleshooting Guide GVW9959 Page 8/27. Our Free Kenmore Washing Machine Repair Manual was designed to assist the novice technician repair of home (domestic) washers that have been operating successfully for an extended period of months or years and have only recently stopped operating properly, with no major change in installation parameters or location. Kenmore Elite Calypso ManualGet shopping advice from experts, friends and the community! The washing machine in the house we are leasing is a Kenmore Elite Calypso Wash Motion Model#10. Does this thing have a filter somewhere. Lately my clothes come out of the washer with stuff all over them.

Download 44 pages, 4.58 Mb

Success! {{ $ctrl.successMessage }}

The obvious things to check per the owner's manual (the non-repair manual), I have already done (make sure no kinks exist in the external pump tube, etc.). I have already taken apart the back panel and bottom panel of the washer, disconnected the external cooregated drain tube (and checked for clogs).

0'>Errors!

11. “FV-SENSE” and “OPEN” Flashing

Flammable Vapor Sensor is open

sensor.

2. Remove the connectors from the

the resistance of the sensor with an

1.7 million ohms, replace the

million ohms, and the wiring from

replace the lower control.

12.“FV-SENSE” and “SHORT” Flashing

Flammable Vapor Sensor is

1. Check all wiring to the ammable vapor

ammable vapor sensor and measure

ohmmeter.

A. If the reading taken is less than

vapor sensor.

B. If the reading taken is more than

control to the sensor is good,

13.“THMSTR” and “OPEN” Flashing

detected the temperature sensor

probe is open.

on again to clear this error code.

2. This part of the control cannot be

cannot be cleared, the lower control must

14.“THMSTR” and “SHORT” Flashing

detected the temperature sensor

probe is shorted.

on again to clear this error code.

2. This part of the control cannot be

cannot be cleared, the lower control must

15.All Segments Flashing

detected one or both of the

are stuck.

temperature adjustment buttons. If the

control will continue to regulate the water

settings will no longer be adjustable – the

16.“P-ANODE” and “OPEN” Flashing

1. Check the wire that runs from the power

wire for damage, and to ensure that the

mating connectors on both ends.

2. Check that the tank is full of water. Never

completely full of water. To prevent

lled with water. Water must ow from

gas to the water heater.

17.“P-ANODE” Flashing

1. Turn the power o for 10 to 20 seconds

cleared, replace the upper control.

10. “LDO-SW”, “OPEN”, and “CLEAN SCREEN” Flashing

intake chamber, retest.

remain open longer than 5

is energized.

special FVS reset sequence into the Electronic

Kenmore Calypso Manual Diagnostic Flame Control

Display - FV - Sense Reset Sequence in

Handbook.

9. “FV-SENSE” Flashing(Continued from previous page)CONTROL DISPLAY STATUSPROBLEM SOLUTION

water heater “OFF” and “ON” to reset.

Kenmore Calypso Manual Diagnostic Flame Detector

“ON” to reset.